Skip to content
All guides

Guides for av fleet operations managers

Vehicle readiness checklist for an AV fleet: charged, cleaned, inspected and cleared for service

A car is ready when four gates are closed on one record: charge at target, the clean signed, the inspection signed with every safety defect certified, and no unrepaired recall. Who closes each gate, what keeps a car back, and how to count the morning.

By XoomPark Editorial Team ·

Ready is not a feeling; it is four closed gates on one record. Charge: at or above the target set for the car's first assignment. Clean: the turnaround clean is signed. Inspected: the walk-around is signed, and every defect likely to affect safe operation has been repaired, with a certification that it was repaired or that repair was unnecessary, before the car runs again.1 Recalls: the VIN shows no unrepaired recall on NHTSA's lookup.3 One open gate means the car is not ready, however good it looks on the stall.
The release gate. Each row is closed by a named person and recorded before the status changes to ready.
GateReady meansNot ready whenWho closes itBasis
ChargeAt or above the target charge for the first assignmentBelow target, or the session stopped earlyDepot manager's charge planOwner's manual target charge level7
CleanTurnaround clean signedNot signed, or the car is on a cleaning holdCleaning crewCDC8
InspectionWalk-around signed; every listed defect certified repaired or unnecessaryA listed defect has no certificationOperations associate, then maintenance49 CFR 396.11;1 396.132
TiresPressure set cold to the door placardThe tire pressure warning is litOperations associateFMVSS 138;5 FMVSS 1106
Recalls0 unrepaired recalls for the VINAn unrepaired safety recall is openOperations managerNHTSA;3 49 U.S.C. 301204

What charge level counts as ready for service?

The charge each car needs for its first assignment plus a reserve you choose, set per car, not a single number for the whole yard. That target is our assumption; the depot manager's charge plan should name it. The car itself can hold it: the owner's manual we use as the example lets the target charge level be raised or lowered on the charging screen, and notes there is a minimum target charge level below which it cannot be set.7

The gate is closed by the number on the car, not by the schedule. A car that was due to finish at 5:00 and stopped at 4:10 because a stall faulted is below target, so it is not ready, whatever the plan says. Record the state of charge at release, so a car that comes back short can be traced to the gate and not argued about.

How do you clear open recalls across an AV fleet?

Run every VIN through NHTSA's lookup and hold any car that shows an unrepaired recall. The lookup takes up to 100 VINs at once, and a clean car returns "0 unrepaired recalls associated with this VIN".3

Know what it will not show. NHTSA says the VIN search leaves out recalls already repaired, some recently announced recalls for which not all VINs have been identified yet, recalls more than 15 years old unless the manufacturer offers more, recalls by small vehicle manufacturers, non-safety campaigns and international vehicles.3 The middle item is why one check at intake is not enough: VINs are added continuously, so a car that was clear last week can show a recall today.3

For a benchmark on speed, look at the rule Congress wrote for rental companies. Once a rental company gets a recall notice for a vehicle, it may rent that vehicle only after the defect is remedied, and it must comply as soon as practicable but not later than 24 hours after first receiving the notice, or 48 hours when the notice covers more than 5,000 vehicles in its fleet.4 Whether your operation counts as a rental company is a question for your compliance lead. Our assumption: hold any recalled car within 24 hours of the notice whether or not the rule binds you, because riders do not care which law applies.

Which open items keep a car from release?

An uncertified defect, a lit tire pressure warning, a missing signature, and an open recall. The federal inspection rule we use as the model says a carrier must repair any listed defect likely to affect safe operation before requiring or permitting the vehicle to operate, and certify the repair, or that it was unnecessary, before the vehicle is operated again.1 The next person to take the car reviews the last report and signs that the certification is there.2
  • Tire pressure warning lit: the federal standard requires the warning to come on within 20 minutes of a tire falling to 25 percent below the manufacturer's recommended cold inflation pressure, or to a minimum in the standard, whichever is higher.5 A lit lamp means the tire is already well low, not about to be.
  • The recommended cold pressure is on a placard permanently affixed to the driver's side B-pillar.6 The owner's manual says to check pressure when the tires are cold7 and lists tire pressures among its once-a-month owner checks;7 a shared car that runs all day needs more than that, so our assumption is a cold check before each service day.
  • Missing signature: a gate with no name on it is open. The inspection report, the repair certification and the review certification are kept three months under the federal rule, and may be kept electronically.1 We suggest the same for every gate.
  • This rule was written for commercial motor vehicles, and it exempts some operations, such as private nonbusiness carriers of passengers and carriers running a single commercial vehicle.1 Whether it covers your cars is for your compliance lead; the release gate works the same either way.

How do you report AV fleet readiness each morning?

One status per car, taken from its open gates, counted at a fixed time. With 60 cars on the roster, 6 in repair, 2 on recall hold and 4 still below charge target at 5:30, 48 cars are ready: 80 percent.

The numbers above are an example, not measured figures; the arithmetic is the point. Use six statuses and let each car carry exactly one: ready, charging, cleaning, inspection hold, repair, recall hold. A car with two open gates takes the one that will take longest to close. Report the ready count against the number of cars the first wave needs, and the four charging cars are the ones to watch: they turn into ready cars on their own, while repair and recall holds do not.

When stalls are the reason cars miss the charge gate, XoomPark arranges AV fleet charging at existing stations in the hours their stalls sit unused, never blocks a station's regular customers and never pushes the station past its monthly peak.

When this checklist is the wrong tool

  • You need the walk-around itself: brakes, lights, wipers, tread. That is the inspection guide; this page only checks that it was signed.
  • You need the clean itself, or the car has blood, a needle or broken glass in it. That is the cleaning guide and the depot's exposure plan.
  • The question is whether the driving system is fit to drive. Those checks belong to the vehicle's maker and its trained staff, and no gate here replaces them.
  • You are counting cars for a single shift handover rather than releasing them. A handover note needs the open items and who owns them, which this record feeds but does not replace.

Questions AV fleet operations managers ask

What should a vehicle readiness record include?

The car, the time, and one line per gate: state of charge at release, who signed the clean, who signed the inspection and any repair certification,1 tire pressure set cold to the placard,6 and the result of the recall lookup with its date.3

How often should a depot check for recalls?

At intake and on a schedule after that, because NHTSA adds VINs to recently announced recalls continuously and says to check regularly.3 Our assumption is weekly for the whole roster, using the 100-VIN bulk lookup, plus a check whenever a recall notice arrives.

Can a car go out with the tire pressure light on?

Not from this gate. The warning is required to come on once a tire is 25 percent below its recommended cold pressure,5 so the light means set the pressure cold to the placard6 and find out why it dropped before the car is released.

Who decides a car is ready?

Nobody decides; the record does. Each gate is closed by the person who did the work, and the operations manager owns the recall gate and the final count. A car with any open gate is not ready.

How long should readiness records be kept?

The federal inspection rule keeps the report and its certifications for three months, electronically if you like.1 Keeping every gate for the same period is our recommendation, not a requirement for your cars.

Authorship

Written by XoomPark Editorial Team in collaboration with Claude Opus 5.5

Role breakdown: Topic selection and publishing by XoomPark Editorial Team; research, source checks against primary sources and draft prose by Claude Opus 5.5.